Operating Manual - WELDY miniwelder geo2 Instrucciones De Funcionamiento

Operating instructions
GB
Please read operating instructions carefully before use
and keep for further reference.
WELDY miniwelder
Wedge Welder
10
Warning
DANGER!
Danger when opening up the device, as components and connections are ex-
posed. Therefore, before opening it, unplug the device to ensure disconnection
from the mains.
Danger of fire and explosion! Incorrect use of the automatic welder (e.g.
overheating of the material) can present a fire and explosion hazard, especially near
combustible materials and explosive gases.
Danger – can cause burns! Do not touch bare metal parts and emerging
material while hot. Allow the device to cool down.
Only connect the tool to a receptacle with protective earth conductor. Any dis-
connection of the protective earth conductor, in or outside the tool is dangerous!
Use line/mains extension cables with protective earth /ground conductor
and adequate cross sectional area only!
Moving parts may not be touched. The danger exists of inadvertently becoming
caught and being pulled in.
While working on the open system avoid wearing garments such as shawls,
scarves and ties. Long hair must be tied or protected by headgear.
Caution
The voltage rating stated on the device must correspond to the mains voltage.
230
In case of a power loss, the potentiometer drive speed (12) and potentiometer
400
heating (15) had to be set to 0.
FI
For personal protection on building sites we strongly recommend the device be
connected to a RCCB (Residual Current Circuit Breaker).
The device must be operated under supervision. Heat can ignite flammable
materials which are not in view. The machine may only be used by qualified
specialists or under their supervision. Children are not authorized to use
this machine.
Protect device from damp and wet.
(Translation of the original operating instructions)