Senix CSE10-L Manual Del Operador página 20

REPLACING THE SAW CHAIN
AND CHAIN BAR
WARNING!
Do not connect the chain saw to extension
cord and power source before it is completely
assembled. Always use gloves when handling
the chain.
WARNING!
When handling saw chains, always wear
protective gloves.
APPROVED SAW BAR/SAW CHAIN:
Saw Bar model:
Saw Chain model: 3/8LP-A-52
Replace chain when cutters are too worn
to sharpen or when chain breaks. Only use
replacement chain noted in this manual.
Always include new drive sprocket when
replacing chain. This will maintain proper
driving of chain.
1. Place the saw body on a firm and level
surface.
2. Use a hexagon wrench to turn the saw's
screw anticlockwise to (Fig. 19) to remove
the cover from the saw's body.
3. Wearing protective gloves, wrap the saw
chain around the chain bar, making sure
that the teeth are aimed in the direction of
rotation. The chain should be properly set
in the slot running along the entire outside
edge of the chain bar.
4. Place the saw chain around the sprocket
(Fig. 20) while lining up the slot in the chain
bar with the internal bolt at the base of the
saw and the chain tensioning pin in the
chain bar's pin hole (Fig. 20). The chain
tensioning pin may need adjustment to
properly align with the hole in the chain bar.
Use the chain tensioning screw to adjust its
location until it fits in the chain bar.
5. Turn the chain tensioning screw to
preliminarily tighten the chain bar enough
that it stays in place. While holding the bar
still, place the cover back onto the saw.
Make sure the tab properly lines up with
the slot on the body of the saw. Lock the
cover in place with saw's screw by turning
it clockwise until it engages. Adjust the
chain tension.
WWW.SENIXTOOLS.COM
YS14-52-507P
REPLACING THE POWER CORD
If the supply cord of this power tool is
damaged, it must be replaced by a specially
prepared cord. Inspect the power cord and
plug often. If damaged, have replaced by a
qualified service dealer.
Sprocket
Fig. 19
Internal Bolt
Chain Tensioning Pin
Fig. 20
19