D-Link DWR-116 Guía De Instalación Rápida página 5

TrOUBLEShOOTING
setuP AND CoNFiGurAtioN ProBleMs
1. hOW DO I CONFIGUrE MY DWr-116 3G/4G WIrELESS N300 MULTI-WAN
rOUTEr WIThOUT ThE INSTALLATION CD, Or ChECK MY WIrELESS NETWOrK
NAME (SSID) AND WIrLESS ENCrYPTION KEY?
- connect your pc to the dWR-116 using an ethernet cable.
- open a web browser and enter the router address: http://192.168.0.1
- the default username is admin. the default password is blank (leave this box empty).
- If you have changed the password and cannot remember it, you will need to reset the router to
factory defaults in order to set the password back to blank.
2. hOW DO I rESET MY DWr-116 3G/4G WIrELESS N300 MULTI-WAN rOUTEr TO
FACTOrY DEFAULT SETTINGS?
- ensure that the dWR-116 is plugged in and receiving power.
- press and hold the reset button on the front of the device for 5 seconds.
Note: Resetting the product to the factory default will erase the current configuration.
to reconfigure your settings, log into the dWR-116 as outlined in question 1, then run the
setup Wizard.
3. hOW DO I ADD A NEW WIrELESS CLIENT Or PC IF I hAVE FOrGOTTEN MY WIrELESS
NETWOrK NAME (SSID) Or WIrELESS ENCrYPTION KEY?
- For each pc that needs to connect to the dWR-116 wirelessly, you must ensure that the correct
Wireless network name (ssId) and encryption key has been entered.
- use the web based user interface (as described in question 1 above) to verify or choose your
wireless settings.
- make sure you write down these settings so that you can enter them into each wirelessly
connected pc. You will find a dedicated area on the back of this document to write down this
important information for future use.
4. WhY AM I UNABLE TO ESTABLISh AN INTErNET CONNECTION?
- If connecting using a 3G/4G connection, make sure that you are within range of the mobile
service provider, and that the service has been correctly configured.
- If connecting using the Wan via adsl /cable service, make sure the modem has been enabled/
connected and is operational, and that the service is correctly configured.
DWr-116
5