ECOFOREST ECO GLASS 70 Manual De Instalación, Uso Y Mantenimiento página 30

Maximum power.

Move the combustion air damper to the left (direction + Figures 19 and 20).
Lower performance, high fuel consumption, clean glass and low emissions. Fully open the combustion air
regulator until the stove is burning well. This position should just be used to light the stove. Once the fire
is lit, it is recommended to move the slider to the right, controlling the power and performance as
desired.
Maximum Performance.

Move the combustion air damper to the right (direction + Figures 19 and 20).
Less heat output, low fuel consumption, glass not as clean and relatively high gas emissions. Close the
combustion air damper until the flame almost out. The stove will burn for many hours but the glass will
probably get dirty, which is a sign of incomplete combustion.
High power and performance.

Relatively low fuel consumption, clean glass, reduced levels of emissions. Gradually close the combustion
air damper to create a slow, gentle flame. In this position, a stove full of wood will burn for a long period
with high performance.
Note: Ecoforest recommends this regulation, for its superior power, high performance and low pollution
level.
6. TURN ON.
6.1. LIGHTING THE STOVE FOR THE FIRST TIME.
The first time it is lit, the stove will give off a slight smell of paint. It is recommended that the room be
thoroughly ventilated during this first ignition.
Light the stove for the first time, and at the start of each season, using little fuel and a gentle flame. In this
way, the stove will adapt to its location better. Also, after a long period of inactivity, check that the flue and
the combustion air inlets are free from obstructions.
Even so, after the lighting as indicated, never build prolonged intense fires. The extra yield that can be
obtained will not offset the high wear the stove will suffer.
6.2. Lighting from cold
Open the door.

Place crumpled paper or a firelighter.

Cover with kindling and some chips, upright.

Light the paper or tablet and close the door. Move the combustion air damper (

5.4.).
Drawing 21
29

) to the left (see section