Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Existing construction accessible only from below
D11
D12
EXISTING FAN
Move the housing into position above the ceiling.
Remove an existing fan and check to make sure the opening is
large enough to accommodate the new motor housing (8"x 8.5").
D13
D14
Attach existing ducting to duct connector. Tape joints. If ducting
Pull wires through strain relief.
does not fit securely, an adapter may need to be purchased.
D15
D16
F1
Install the housing flush with the sheetrock and secure by
Go to step F1 on page 20 to connect the wires as shown.
tightening the pre-loaded screws into the joist.
15
43053-01 12/01/2013
Tabla de contenido
