MAAX Utile Guia De Instalacion página 13

5
Temporary installation of the
STEP
side walls (Cont'd)
Install the side wall (15). Lift the wall approximately 3"
above the threshold of the base, push it completely
against the back wall then lower the side wall into
position.
It is critical that all 3 retraction pins
engage with the X fasteners. There
should be no gap between the walls.

Place a level vertically
Quick tip
on the side wall. If the
wall is not straight,
make sure that the
retraction pins are
properly inserted in
the X fasteners.

The side wall should now line up
Quick tip
with the front of the base. If it does
not, remove the walls and shim
the back fl ange of base.
With a 1/8" bit, drill holes in the side wall fastening flange
(15) at the top aligned with each stud. Only pre-drill
the flange not the studs. Then, secure the side wall
(15) with one #8 x 1¾" screw (not included) in one of the
pre-drilled holes.
IMPORTANT: HAND TIGHTEN ONLY. TEMPORARY
INSTALLATION.
5.4
Check me!
Side wall
Base
5.5
Check me!
13
3
Side wall
1
15
Back wall