Global Mode; Program Change Mode - Akai Professional MPD26 Guia De Inicio Rapido

GLOBAL MODE

In Global Mode, you can send
global messages and make general
changes to the way that your
MPD26 functions.
options are organized
different pages and include the list
of options shown below.
MIDI COMMON CHANNEL
LCD CONTRAST
PAD SENSITIVITY
PAD VELOCITY CURVE
PAD THRESHOLD
TAP TEMPO AVERAGE
SAVE SETUP

PROGRAM CHANGE MODE

A Program Change, often referred to as a
Patch Change, is a MIDI message used for
sending data to devices to cause them to
change to a new program.
There are two different types of Program
Change messages on the MPD26:
PROG CHANGE – This event will transmit
a regular Program Change message (0-
127) to your DAW or an external device,
allowing you to switch between 128
different program banks.
PROG+BANK – This event transmits a Program Change message (0-127), along with a Bank L (Least
Significant Byte) Change message (0-127) and a Bank M (Most Significant Byte) Change message (0-126),
which allows access of up to 16384 different program banks. You can use PROG+BANK if your DAW or
external device supports LSB and MSB.
1.
Global Mode
2.
under
3.
4.
KILL MIDI Send an All Notes Off or Reset Controllers message
Select which MIDI channel will be used as the
Common Channel.
Adjust the contrast of the display.
Adjust how sensitive the pads are to the touch.
Adjust how the pads will output MIDI velocity, based
on the force applied to them.
Adjust the threshold of minimum force required to
activate a pad.
MIDI CLOCK Select Internal or External MIDI Clock source.
Select the number of taps to be averaged in
determining tempo.
Save the current global settings.
Transfer a Preset via SysEx.
SYSEX TX
VERSION Check the current firmware version.
NAVIGATING GLOBAL MODE
Press [GLOBAL] to enter Global Mode.
Use [<] and [>] to navigate through the available pages of
options (shown below).
Use the [VALUE] dial to change settings, values or select a
message on the selected page.
Press [ENTER] to accept the change or send a message
or press [<] to cancel.
NAVIGATING PROGRAM CHANGE MODE
1. Press the [PROGRAM CHANGE] button.
2. On Page 1, use the [VALUE] dial to select a Prog
Change or Prog+Bank message on and press
[ENTER].
3. On Page 2, use the [<] and [>] buttons to move
through the different options and use the {VALUE]
dial to change them.
4. Press [ENTER] to send the message.
7
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11