Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Board has excessive bow or twist along its
length. Surface plane one face so there is a
good surface to position against the fence.
Insufficient number of passes. It may take 3 to
5 passes to achieve a perfect edge, depending
on the starting condition of the board and the
depth of cut.
UNEVEN CUT OR BREAKOUT WHEN RABBET-
ING
Uneven feed rate. Feed the board evenly and
smoothly during the cut.
Depth of cut too deep. Raise the infeed table
to take a smaller depth of cut. Never exceed
1/16" per pass when rabbeting.
Knives not adjusted evenly with each other in
the cutterhead. Adjust the knives so they are
set up evenly in the cutterhead.
Nicked or chipped knives. Adjust one of the
nicked knives sideways; replace knives.
36
TECHNICAL DATA
Dimensions
Table (Length/Width)
Table (Height)
Fence (length/width)
Motor
Power/Voltage
Phases
No load speed
Cutter head information
Cutter head diameter
Knives
Cutter head speed
Cutting capacity
Maximum cutting depth
Maximum rabbeting depth
Additional Information
Expulsion port
Weight
46" x 6 1/8"
(1 168 mm x 156 mm)
32 3/8" (822 mm)
4 1/2" x 29 3/8"
(113 mm x 745 mm)
746 W 120/220 V ~
1 ~
3 450 r/min
2 1/2" (63,5 mm)
3
5 000 r/min
1/8" (3,175 mm)
12,7 mm
4" (101 mm)
102 kg (225 lb)
Tabla de contenido
