Urrea CN1106 Manual De Usuario Y Garantía página 31

on the portion of the workpiece that is on the
outfeed table. Now, focus your pressure on the
outfeed end of the workpiece while feeding,
and repeat the same action with your trailing
hand when it gets within 4" of the cutterhead.
To keep your hands safe, DO NOT let them get
closer than 4" from the cutterhead when it is
moving!
8. Repeat Step 7 until the entire edge is flat.
BEVEL CUTTING
The purpose of bevel cutting is to cut a specific
angle into the edge of a workpiece.
This Jointer has preset fence stops at 45˚ in-
ward, 90˚, and 45˚ outward (135˚). If your situ-
ation requires a different angle, the fence can
be locked anywhere between these angles.
NOTICE: If you are not experienced with a
jointer, set the depth of cut to zero, and prac-
tice feeding the workpiece across the tables
as described below. This procedure will better
prepare you for the actual operation.
TO BEVEL CUT ON THE JOINTER
1. Read and understand SECTION "SAFETY..."
2. Make sure your stock has been inspected for
dangerous conditions as described in the Stock
Inspection & Requirements instructions.
3. Set the cutting depth for your operation.
(We suggest between 1⁄16" and 1⁄8" for bevel
cutting, using a more shallow depth for hard
wood species or for wide stock.)
4. Make sure your fence is set to the angle of
your desired cut.
E N G L I S H •
5. If your workpiece is cupped (warped), place
it so the concave edge is face down on the sur-
face of the infeed table.
6. Start the jointer.
7. With a push block in your leading hand,
press the workpiece against the table and
fence with firm pressure, and feed the work-
piece over the cutterhead.
NOTE: If your leading hand gets within 4" of
the cutterhead, lift it up and over the cutter-
head, and place the push block on the portion
of the workpiece that is on the outfeed table.
Now, focus your pressure on the outfeed end
of the workpiece while feeding, and repeat
the same action with your trailing hand when
it gets within 4" of the cutterhead. To keep
your hands safe, DO NOT let them get closer
than 4" from the cutterhead when it is mov-
ing!
8. Repeat Step 7 until the angled cut is satisfac-
tory to your needs.
RABBET CUTTING
The purpose of rabbet cutting is to remove
a section of the workpiece edge. When com-
bined with another rabbet cut edge, the rab-
bet joints create a simple, yet strong method
of joining stock.
NOTICE: If you are not experienced with a
jointer, set the depth of cut to 0", and practice
feeding the workpiece across the tables as de-
scribed. This procedure will better prepare you
for the actual operation.
U ser 's manual
31