Technical Data - Urrea CN1108A Manual De Usuario Y Garantía

LONG LINES OR RIDGES THAT RUN ALONG THE
LENGTH OF THE BOARD.
Nicked or chipped knives. Adjust one of the
nicked knives sideways; replace knives.
UNEVEN CUTTER MARKS, WAVY SURFACE, OR
CHATTER MARKS ACROSS THE FACE OF THE
BOARD
Feeding workpiece too fast. Slow down the
feed rate.
Knives not adjusted at even heights in the cut-
terhead. Adjust the knives so they are set up
evenly in the cutterhead.
BOARD EDGE IS CONCAVE OR CONVEX AFTER
JOINTING
Board not held with even pressure on infeed
and outfeed table during cut. Hold board with
even pressure as it moves over the cutterhead.
Board started too uneven. Take partial cuts to
remove the extreme high spots before doing
a full pass.
Board has excessive bow or twist along its
length. Surface plane one face so there is a
good surface to position against the fence.
Insufficient number of passes. It may take 3 to
5 passes to achieve a perfect edge, depending
on the starting condition of the board and the
depth of cut.
UNEVEN CUT OR BREAKOUT WHEN RABBET-
ING
Uneven feed rate. Feed the board evenly and
smoothly during the cut.
Depth of cut too deep. Raise the infeed table
to take a smaller depth of cut. Never exceed
1/16" per pass when rabbeting.
Knives not adjusted evenly with each other in
the cutterhead. Adjust the knives so they are
set up evenly in the cutterhead.
Nicked or chipped knives. Adjust one of the
nicked knives sideways; replace knives.
34

TECHNICAL DATA

Dimensions
Table (Length/Width)
Table (Height)
Fence (length/width)
Motor
Power/Voltage
Phases
No load speed
Cutter head information
Cutter head diameter
Knives
Cutter head speed
Cutting capacity
Maximum cutting depth
Maximum rabbeting depth
Additional Information
Expulsion port
Weight
8" x 72 1/8"
(203 mm x 1832 mm)
32" (820 mm)
5" x 35"
(127 mm x 890 mm)
1 491 W 220 V ~
1 ~
3 450 r/min
3" (74 mm)
4
5 000 r/min
1/8" (3,175 mm)
12,7 mm
4" (101 mm)
184 kg (405 lb)