Connecting The Water Supply Line - Glacier bay N2316 Guía De Uso Y Cuidado

Installation (continued)
7
Installing and adjusting the flush
button
□ Position the flush button mechanism (QQ) in tank lid so the
single drop button will align with blue lever (half flush) on top of
the flush valve and double drop button aligns with the white
lever (full flush).
Secure the flush button mechanism (QQ) in the tank lid by
□
hand tightening the lock nut (1).
The rubber tip on the bottom of the push rods leading from the
□
flush buttons should lightly touch the top of the levers on the
flush valve.
To increase the rod length, turn the rod locknut counter-
□
clockwise to loosen, then rotate the push rod counter-clockwise
to increase exposed length. When the desired length is
achieved, turn the rod locknut clockwise, while holding the
push rod, until it is tightened.
8

Connecting the water supply line

□ Connect the water supply line (not included) between the
tank (A) and shut-off valve.
Tighten the tank connection coupling nut ¼ turn beyond hand
□
tight.
Turn on the supply valve and allow the tank (A) to fill.
□
□ Check for leakage at all connections and tighten or correct as
needed.
NOTE: Do not overtighten the tank connection.
7
Please contact 1-855-434-5224 for further assistance.
HOMEDEPOT.COM