Installing The Toilet; Securing The Toilet - Glacier bay N2316 Guía De Uso Y Cuidado

Installation (continued)
3
Installing the wax ring
□ Turn the toilet bowl (B) upside down onto a towel or cushioned
surface. With the rounded (tapered) end of the wax ring (CC)
facing the toilet, place the wax ring (CC) around the raised
outlet ring of the bowl (B), and press firmly enough so the wax
ring (CC) adheres to the bowl (B).
5

Securing the toilet

From the backside of the toilet (B), place the plastic discs (DD)
□
over the floor bolts (AA), noting 'this side up' on the top of the
discs.
Tighten the floor bolt wing nuts (EE) onto the floor bolts (AA) to
□
secure the position of the plastic discs (DD).
□ Place the bolt cap covers (FF) over the floor bolts (AA) and
snap into place.
4

Installing the toilet

□ Place the toilet bowl (B) over the toilet flange (1) in alignment
with the floor bolts (AA) so they protrude through the slots on
the base of the toilet bowl (B). Press down on the toilet bowl
(B).
6
Installing the tank
Attach the rubber sealing gasket (KK) to the center drain hole
□
under the tank (A).
Gently place the tank (A) on the toilet bowl (B) with bolts (II)
□
protruding out underneath.
Place an oval metal washer (LL) followed by a wing nut (MM)
□
onto each protruding bolt (II).
Tighten the wing nuts (MM) enough so that the tank (A) sits flat
□
on the toilet bowl (B). Make sure the tank (A) is parallel to the
wall and straight on the toilet bowl (B).
CAUTION: Do not overtighten the nuts. Severe damage
may occur.
6