Changing The Pcmcia Radio - Mettler Toledo 8450 Manual De Servicio

Changing the PCMCIA
Radio
The radio in the Mercury-PC adapter is a PCMCIA card. To change the radio, first remove
the two cover screws as shown below and then remove the cover.
Next, slide the PCMCIA card out from the adapter. Disconnect the antenna leads from the
card. Reconnect the antenna leads to the new card, then slide the new radio in the
adapter. Push the card in until you can feel the card plug into the receptacle. Route the
antenna leads out the top of the adapter and on top of the strain relief block so they are
clamped in place when the cover is installed.
Strain Relief Block
Replace the adapter cover. See the previous section "Mercury-PC Setup" to initialize and
configure the new radio.
Capítulo 3: Configuración de la unidad
Slide the card out
from the adapter, and
disconnect the
antenna wires.
(6/00)
Ethernet RF
3-31