Tabla de contenido
Note: On a Symbol® 802.11 network, a
single node is supported when "dsmu =
no". To support bridging of multiple
Ethernet devices, change to "dsmu = yes"
in the screen to the right. In the Access
Point, WLAP mode must be enabled.
To use both antennas, you must add the
line "diversity = yes" as shown to the
right, which may increase the distance
that scale can be located away from the
Access Point.
which you will communicate. If the value does not match, access to the system is not
granted. The SSID can be up to 32 characters (case sensitive).
The "node name" is registered at the Access Point. The station name is displayed in the
table of connected devices on the Access Point. It provides a logical name to determine
which machines are connected without having to memorize every MAC address. The
name can be up to 16 characters.
The "ip address" and "netmask" are optional and are used only for remote management
of the wireless bridge through the network using a Telnet session.
Press Control-W to save and exit the screen or Control-X to exit without saving changes.
The following screen shows the setup parameters with a Symbol
installed.
[hardware]
network id = 101
mac address = detect save
# station or microap
radio mode = station
dsmu = no
transmit rate = 1 2
diversity = yes
[rmp]
ethertype = 0x4e43
[ip]
ip address = 10.10.10.128
netmask = 255.255.255.0
broadcast = automatic
route = automatic
gateway = none
File: lan0
Line #: 1
^P: up ^N: down ^B: back ^F: forward ^W: write file ^X: exit w/out saving
Bridged Ethernet Setup Screen for Symbol
Capítulo 3: Configuración de la unidad
®
PCMCIA radio
®
Radio
(6/00)
Ethernet RF
3-29
Tabla de contenido
