Troubleshooting - Best Power Patriot 250U Guia Del Usuario

Troubleshooting

If you have a question or problem, the troubleshooting table may help. (See Table 3.)
Table 3: Troubleshooting
Problem
Green
OPERATING
Red LED off,
FAULT
One beep every five seconds.
Green
OPERATING
Red LED off,
FAULT
Two beeps every five seconds.
Green
OPERATING
Red LED blinks,
FAULT
Three beeps every five seconds.
Green
OPERATING
Red LED off,
FAULT
Three beeps every five minutes.
Green
OPERATING
Red LED blinks,
FAULT
One beep every half-second.
Green
OPERATING
Red LED on,
FAULT
Continuous beep.
* If Patriot is unable to charge the battery after 24 hours in the 3-beeps/5-minutes alarm state,
the alarm changes to 3 beeps/5 seconds, indicating the battery must be replaced.
Possible Reasons
LED blinks, 1. Utility power outage.
2. Loose plug.
3. Tripped circuit breaker.
4. Power cord failure.
LED blinks, Very low battery voltage.
LED on, 1. Battery not charged
following extended
storage.
2. Unit has failed the
battery test.
LED on, Battery not charged
following a power
outage.*
LED on, The power required by the
equipment is too high.
LED off, 1. Output short circuit.
2. Input voltage is out of
range when unit is
turned on.
3. UPS fault.
1. Wait for power to return.
2. Make sure the power cord is
connected.
3. Reset the circuit breaker.
4. Phone Best Power's Worldwide
Service.
Plug the unit into a working wall outlet
for at least 8 hours to allow the batteries
to charge. If the batteries do not
recharge, the Patriot will not operate on
battery power, or it will beep twice
every five seconds immediately. In this
case, phone Best Power's Worldwide
Service.
1. Turn the unit off but keep it plugged
into a working wall outlet for at least
3 hours. Then turn it on to run the
battery test again.
2. If alarm still sounds after the unit has
been charged as described above,
replace the battery as described on
pages 8 and 9.
Use the unit on utility power; wait for
full recharge. The beeps stop automati-
cally when the battery is charged.
1. Remove load equipment.
2. Reduce load level until the beeping
stops.
1. Turn off or unplug load equipment.
2. Turn unit off until acceptable input
voltage is restored.
3. Phone Best Power's Worldwide
Service.
7
What To Do
ENGLISH