4. Installation
I
Check what is inside the package
• Check to see if the following parts are included in the purchased package.
tab screw
Camera
I
Notes on installation and usage
1. Users should not disassemble the camera from the front direction.
2. Always handle the camera with care. Please do not apply a shock or vibration
as much as possible and take cautions not to cause damage or make a
scratch on the camera due to careless storage.
3. Please do not install the camera with the rainy place or highly humid areas.
And do not operate the camera in the wet place.
4. Do not clean the camera body with the strong abrasives or soaps. When the
camera becomes dirty, clean it with the dry rugs. Especially, make sure to use
the dedicated rugs for lens to clean the dome cover.
5. Please keep the camera at the cool area that is not exposed to the direct
sunlight. If you do, it can cause bad effects on the product.
6
User Guide
I
Installation
1. Raise the COVER-DOME towards the FRONT
direction to separate from the product.
2. Move the PUSH arrow in alignment with the
BOTTOM arrow, and then turn the BRACKET
User's guide
CEILING anti-clockwise while pressing the PUSH
part to detach.
3. Move the BRACKET-CEILING CAMERA mark
towards the desired direction, and then screw down
the screw including as an ACCESSORY to fix in
position.
4. Create a hole in the ➀ installation position.
If the CAMERA wiring comes from the bottom,
remove a part of the centre and remove the cable
from the hole.
User Guide
7
E