PNI Escort Start360 Manual De Usuario página 32

D. If remote start is not needed or the car needs to stop without leaving gear
lever in Neutral position (such as parking the car on a slope), pressing the brake pedal
when pull out the ignition key, thus to stop the engine instead of setting remote start
reservation.
23.Protection for Turbo Engine
1)This function is designed for the car equipped with turbo engine. It can keep
the engine running for the pre-programmed period of time after you pull off the Ignition
Key. When engine is running idle, the temperature in turbo system will drop gradually, it
can effectively prevent from the rise of engine temperature due to abrupt stop so as to
minimize the damage of the turbo bearing caused by the coking of engine oil of higher
temperature. This can effectively extend the service life of the engine. (Only system
with remote engine start has this function.) If the brake pedal is pressed during the pre-
programmed engine running time, the main module will stop the engine immediately. If
the brake pedal is pressed at the same time when the key is turned to OFF position, the
main module will stop the engine immediately and will not keep it
running, which is applicable for a manual transmission car to leave the gearshift not in
the neutral position for stopping and parking on the slope.
2)For a manual transmission car, after the car is stopped, when setting the
main module to Reservation Mode, just follow the procedures to open and close the
door to finish the setting, however, the engine is still keeping running, which indicates
that turbo engine protection is working.
24. System features programming
To enter the system features programming mode: while the alarm system is
disarmed, turn the ignition ON then stay ON, press and hold the brake pedal, then press
and release the Override/Valet Switch 5 times, the siren will chirp once to indicate the
system has entered the programming mode.
A. Engine run time selection: 8, 16, 24, 60 minutes
While the system is in programming mode:
a. Press button once, the siren will chirp twice, the turn signal lights will flash twice,
indicating the 16-minute engine run time is selected.
b. Press button once again, the siren will chirp 3 times, the turn signal lights will flash
3 times, indicating the 24-minute engine run time is selected.
c. Press button once again, the siren will chirp 4 times, the turn signal lights will flash 4
times, indicating the 60-minute engine run time is selected.
d. Press button once again, the siren will chirp once, the turn signal lights will flash
once, indicating the 8-minute engine run time is selected. The default setting is 8
minutes. Every time when the power supply of the system is disconnected then
connected again, it will return the engine run time to the default setting 8 minutes. (Only
system with remote engine start has this function.)
31 31
EN