Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Hanging installation:
To use the PHOENIX 2.8 air circula-
tion heater as a hanging apparatus,
the supplied chains must first
be fitted. The following supplied com-
ponents are required for assembly:
2 x PHOENIX hanging chains
2 x T-head Bolt and Ring Nut
The PHOENIX heater comes with
metal lugs on the housing to hook the
chains, using the snap hooks. The
other two snap hooks then hook into
the V-hooks. These V-hooks are then
fastened to the profiles in your green-
house (see illustration on Page 2).
Your PHOENIX greenhouse heater is
now ready to use as a hanging heater.
6. Operation
Connect the heating apparatus to any
240 V ~ 60 Hz AC socket. The PHOE-
NIX air circulation heater has two
selector switches and a thermostat.
Using the selector switches, you may
select one of the 8 possible operating
modes. Set the desired greenhouse
temperature on the thermostat. An in-
tegral lamp signals heating operation.
Selector 2
On/Off lamp
Thermostat:
The thermostat is linear and infinite-
ly variable from 32-37°F. The printed
figures from 0-10 on the adjustment
wheel are for general orientation to
the temperature range being selected.
This means that the increasing num-
bers each mean a rise in temperature
of approx. 37 °C (see example below).
Example.: Number Temperature range
0 - 1 ≈ 32 - 37 °F
1 - 2 ≈ 37 - 42 °F
2 - 3 ≈ 42 - 46 °F
3 - 4 ≈ 46 - 51 °F
etc.
Refer to page 9 in the section 'winter
operation' to find out how to set the
temperature exactly.
Selector 1
Winter operation:
8
0 - 2.6 °C
2.6 - 5.2 °C
5.2 - 7.8 °C
7.8 - 10.4 °C
Thermostat
Tabla de contenido
