Supply; Choosing The Installation Location - Vortice THERMOLOGIKA SOLEIL SYSTEM Manual De Instrucciones

ENGLISH
• Before carrying out any type of cleaning or maintenance operation, turn the appliance off and turn the main
power switch off to disconnect it from the power supply.
• Should the appliance be dropped or suffer a heavy blow, have it checked immediately by Vortice.
• When carrying out maintenance operations, never touch the bulbs directly, but only the terminal casings. The
bulb will be damaged by contact with naked hands; in this eventuality the product guarantee will no longer be
considered valid.
• In the event of accidental contact with the surface of the bulb, clean it immediately by wiping with a cloth
dipped in alcohol.
• If the appliance does not function correctly or develops a fault, turn it off and contact Vortice* immediately.
• Ensure that only genuine original Vortice spares are used for any repairs. If the power supply cable is damaged,
it must be replaced by the manufacturer or by an authorized Vortice Technical Assistance Center, in order to
prevent any risk."
• Switch off the appliance at the main switch: a) if the appliance does not function correctly; b) before cleaning
the outside of the appliance, c) if the appliance is not to be used for long periods of time.
• Do not cover or block the front heat irradiation grille.
• Do not cover or block the appliance during use.
• Keep the front grille clean.
• The appliance's safety guard has been specially designed to prevent direct access to the heater elements; this
guard must be kept in position at all times during operation.
CAUTION: This heating device is not equipped with a room temperature control device. Do not use in small
rooms when they are occupied by people unable to leave the room alone, unless they are under constant
surveillance.

Supply

TSS devices are equipped with:
- Infrared lamp;
- Cable mod. H05SS-F 3x1.00 mmI ;
- Bracket and accessories for wall and ceiling installation (fig 2);
- Front steel grille.

Choosing the installation location

Never install TSS near flammable surfaces nor direct it in towards any.
TSS must be set at a distance of no less than 2 m from objects made of flammable materials, such as cardboard
or fabric, as well as from windows.
In any case, do not install the lamp inclined directly towards a wall or towards the ceiling. (fig.9 - fig.14)
TSS is not suitable for installations in very dusty environments where the bulb could become damaged.
CAUTION: TSS must not be installed directly under a power outlet.
9