BOMANN TSG 7404 Instrucciones De Servicio página 57

 Power cord and water hoses may not kinked or
squashed.
 Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors),
-
as metal parts would be susceptible to corro-
sion under such circumstances;
in rooms where the temperature could drop
-
below freezing. Do not expose the appliance
any weather.
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.).
Water connection
CAUTION:
 The Installation of the water supply must conform
to the local laws and regulations.
 Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
 If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose safety system (delivery scope
depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop, www.bomann-germarny.de. To order, use the
reference number found under "Technical Data".
Connect the water inlet hose (cold water connection)
NOTE:
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.
 Connect the water inlet hose to a
water thread with ¾". Screw the
hose firmly in the direction of the
screw thread; pay attention for a
tight fit.
 Connect the other end of the inlet
hose to the inlet valve on the ap-
pliance back; pay attention for a
tight fit too.
Hot water supply
The dishwasher can be supplied with a water tem-
perature of not more than 60°C. Supplying the appli-
ance with hot water, the rinse running time is short-
ened but the cleaning effect can be slightly reduced.
The connection to the hot water valve must be done
in the same manner as described for the cold water
connection.
Connect the water drain hose
NOTE:
The drain hose has a length of approx. 1.5 m and
can extend with a suitable hose and connecting
piece to a length of max. 4 m.
CAUTION:
In order to prevent backflow of contaminated water,
the free end of the hose must not come under the
water level of the drain.
57