Levelling - Fulgor Milano Professional 36 Built-In Serie Guia De Instalacion

EN
Professional Series:
FIG.2 - BACK OF APPLIANCE
Electrical connection
Operate as follows:
• Unwind the electric cable and connect it directly to the
wall socket.
• Make sure the appliance is in the Stand-by condition and
that all ights are off; should it be not so press the Unit
button to switch it off.
FIG.3 - FRONT OF APPLIANCE
1
• Firmly tighten with fingers - a tool / wrench should not
be needed to make a proper seal. Turn on the water and
ensure all connections are not leaking prior to pushing
the unit into the niche.
8
Water connection

3.4 Levelling

Adjust the appliance level by means of the front levelling
feet and the rear adjustable wheels
2
1
Operate as follows:
• If necessary, remove the bottom plinth or grille (it is kept
in position by magnets), adjust the height of the levelling
feet [ 1 ] by means of a 17 mm (11/16") wrench.
• Then adjust the height of the rear wheels by turning the
front adjusting bolts [ 2 ] clockwise (raise) or counter-
clockwise as it may be required.
Take care if using a power driver for this and lower the
clutch to prevent damaging the leveling mechanism.
• Remount the bottom plinth or grille.
2
1