Troubleshooting Steps - DeWalt DCV585 Manual De Instrucciones

English
Problem
Motor does not run.
Dust extractor stops running.
Dust comes out of unit while using.
Dust extractor stops capturing dust.
Dust extractor is not turned on by
Wireless Tool Control™ equipped
power tool or remote.
Tool does not pair
14
TROUBLESHOOTING
Possible Cause
Switch is not in On (I) position.
Low battery voltage/poor battery connection.
Tank is full of liquid and sense circuit is tripped.
Thermal overload has been tripped.
Tank is full of liquid and sense circuit is tripped.
Battery is discharged.
Battery is not fully inserted.
Filters not installed properly.
Filters are damaged/torn.
Filter gaskets are damaged.
Head not installed properly to tank.
Head gasket damaged.
Filters clogged.
Filters at end of service life.
Automatic filter cleaning no longer functional.
Tank full.
Hose is clogged.
Hose is not fully connected to tank.
Hose is damaged.
Dust extractor is not in Wireless Tool
Control™ ( ) mode.
Remote/power tool is not paired to
dust extractor.
Remote/power tool is out of range of
dust extractor.
Wireless Tool Control™ remote coin cell is dead. Replace coin cell and retry.
Paired tool's battery is dead.
Low battery voltage/poor battery connection.
Tank is full of liquid and sense circuit is tripped.
Dust extractor is not in Wireless Tool
Control™ ( ) mode.
Tool is not Wireless Tool Control™ enabled.

Troubleshooting steps

Ensure three position switch is in On (I) position.
Ensure battery is fully charged and fully inserted.
1. Turn the three position switch to the Off (0) position and
remove battery.
2. Empty tank.
1. Turn the dust extractor off and remove battery.
2. Empty the tank, if needed.
3. Allow the dust extractor to cool.
4. Resinsert the battery and press the three position switch to
the On (I) position to test.
5. If dust extractor will not restart, call 1-800-4D
(1-800-433-9258).
1. Turn the three position switch to the Off (0) position and
remove battery.
2. Empty tank.
Insert fully charged battery.
Remove and reinsert battery.
Remove and reinstall per proper procedure.
Replace filters.
Contact D WALT service center.
e
Remove, reinstall and ensure latches are fully engaged.
Contact D WALT service center.
e
Remove filters, tap clean and reinstall.
Replace with new filters.
If filter cleaning system is not heard every 20 seconds, contact
D WALT service center.
e
Turn unit off and empty tank.
Inspect and clear hose if clog is found.
Reinsert and ensure hose latch is fully engaged.
Inspect hose for holes or tears. Replace if damage is found.
Move three position switch to Wireless Tool Control™ ( )
mode. Confirm LED is illuminated. If LED is not illuminated
with the 3-position switch in Wireless Tool Control™ ( )
mode, contact D WALT service center.
e
Follow pairing steps.
Move dust extractor closer to remote/power tool.
Ensure paired tool's battery is fully charged and fully inserted.
Ensure battery is fully charged and fully inserted.
1. Turn the three position switch to the Off (0) position and
remove battery.
2. Empty tank.
Move three position switch to Wireless Tool Control™ ( )
mode. Confirm LED is illuminated. If LED is not illuminated
with the 3-position switch in Wireless Tool Control™ ( )
mode, contact D WALT service center.
e
Confirm that tool is Wireless Tool Control™ enabled.
WALT
e