Health O Meter 498KL Instrucciones Para El Usuario página 8

498KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling the 498KL Scale (Refer to Figures 1 – 4)
Note: For wall mounting, mount display assembly directly to the wall. Do not use display
bracket for wall mount. Display bracket is for surface use only.
1. Carefully remove the scale platform with the display assembly from the carton, and place the
scale platform and display assembly on a flat, level, and dry surface (see Figure 3 on page
10).
2. Ensure that the cable is securely connected to the scale platform RJ jack (see Figures 2 & 3
on pages 9 & 10).
3. Remove the display bracket from the carton (see Figure 1 on page 9).
4. Remove the two small screws from plate B (see Figure 1 on page 9).
5. While holding plate A, slide the tab of plate B up and under the center tab on the back of plate
A (see Figure 1 on page 9).
6. Align plate A and plate B, and ensure that the screw holes are lined up (see Figure 1 on page
9).
7. Insert the two small screws into the front of plate A and through the holes in plate B
(see Figure 1 on page 9).
8. Using a Phillips head screwdriver, tighten the screws to secure plate A to plate B
(see Figure 1 on page 9).
9. Slide the two mounting studs on the display bracket into the two mounting holes in the back of
the display assembly (see Figures 1 & 4 on pages 9 & 12). The display bracket is now ready
for use.
8