Battery Power And First Use Recommendation; Intended Use - 3M SD-200 Manual Del Usuario

3M Sound Detector SD-200
TM
SD-200: dangers, warnings, cautions & battery
Danger!
Failure to observe the following procedures may result in serious personal
injury
•
Not for use in explosive or hazardous locations. This product is not intrinsically safe.
•
Contains built-in lithium polymer battery. Do not incinerate or dispose of in fire. Do not
disassemble, alter, or re-construct.
Warning!
Failure to observe the following procedures could damage the instrument
•
Read the manual before operation.
•
Do not store in temperatures exceeding 70°C (158°F).
•
Do not immerse in liquids.
•
Condensation may damage your instrument.
•
Substitution of components may impair the accuracy of the instrument. Repair should be
done by authorized service personnel only.
Caution!
General
•
The battery in this instrument has limited shelf-life, even if never used.
•
A non-condensing environment is required for proper measurements.
•
Do not charge battery outside the range of 0°C to 40°C (32°F to 104°F).
•
Battery run-time may be reduced when operating at lower than 0°C (32°F) temperatures.

Battery power and first use recommendation

It is recommended to fully charge the SD-200 for approximately 12 hours prior to
first use.

Intended Use:

The SD-200 is intended to measure sound pressure levels in air. Consult your
company's safety professional for local standards, or call 3M at 1-800-243-4630.