PRESIDIUM Adamas Manual De Instrucciones página 11

Calibration
1. When the tester is switched off, turn the probe tip anti-
clockwise to remove it, as shown in Fig. 1.07.
Fig. 1.07
2. To insert a new probe tip, position Guide 1 as shown
in Fig. 1.08, slide it in and turn clockwise to align Guide
2 with the guide marked on the main body to secure it as
shown in Fig. 1.09.
Guide 1
Guide 2
Fig. 1.08
Fig. 1.09
the READY Light stops blinking, the tester is ready to
enter calibration mode as shown in Fig. 1.10. This
process may take up to 15 seconds. If the READY Light
continues to blink after 15 seconds, the probe tip may not
be positioned properly. Kindly repeat the procedure from
Steps 1 and 2.
11