9. Put the top cover back and fix it in place with
the screws.
TIPS FOR SAVING ENERGY
For the most energy efficient use of your appliance:
Ensure your fridge has adequate ventilation as recommended in the installation instructions.
Allow warm food and drinks to cool down before placing in the appliance.
Keep door openings to a minimum.
Open the appliance as briefly as possible.
Ensure that the fridge door is always closed properly.
OPERATING NOISES
Normal noises
Motors are running.
Refrigerant is flowing through the tubing.
CLEANING AND MAINTENANCE
Do not use abrasive cleaning agents or solvents.
1. Set the temperature control knob to the OFF position and disconnect the mains plug from the mains
socket.
2. Take out the food and store in a cool location.
3. Clean the appliance with a soft cloth, warm water and detergent.
4. Wipe the door seal with clear water only and then wipe dry thoroughly.
5. After cleaning reconnect and adjust the temperature control knob as desired.
6. Put the food back into the appliance.
Bulb replacement
Beware: Unplug the appliance from the power supply before replacing the light bulb.
1. Remove the bulb cover.
2. Unscrew the old bulb and then screw a new 15W (E14 base) bulb.
3. Replace the bulb cover.
10. With the door closed, check that the door is
13
aligned horizontally and vertically and that
the seals are closed on all sides before finally
tightening the bottom hinge. Readjust the
levelling feet as required.
GB