Hoover FREESPACE CYCLONIC Instrucciones Del Usuario página 7

USING YOUR CLEANER
Power supply - Pull cord and plug into power supply (P4), Please make sure the cord is fully
extended before using the cleaner (do not pull the cord beyond the red marker). Press the on/off
pedal once to start the cleaner (P5). Press it again to stop the cleaner before removing the plug
after use. Press the cord rewind button to wind the power cord back into the cleaner (P6).
Fixed power control (depending on model) - Adjust the suction by moving the handle valve:
suction will decrease when opening the valve (P7). Use low suction for delicate fabrics.
Variable power control (depending on model) - Slide the variable power adjuster to increase or
decrease the power level (P8). Use low suction for delicate fabrics.
Telescopic Tube / Telescopic Tritube (depending on model) – The Telescopic Tube or Tritube
can be extended or collapsed by pressing the latches forward and pulling or pushing the tubes to
the desired length (P9).
Carpet & Floor Nozzle - Press pedal on the nozzle to lower the brush head when cleaning hard
fl oors (P10). Press the pedal again to lift the brush head when cleaning carpets.
Mini Turbo Nozzle (depending on model) - Use the Mini Turbo Nozzle (P11) for deep cleaning
on textile surfaces. Important: do not use the Mini Turbo Nozzle on rugs with long fringes, animal
hide and with carpet piles deeper than 15mm. Do not keep the nozzle stationary while the brush is
rotating.
Multifunction Tool - (P12) This tool can be used as:
1. Crevice tool: for corners and hard to reach areas
2. Dusting brush: for bookshelves, frames, keyboards etc.
Furniture Nozzle (depending on model) - For soft furnishings and fabrics (P12).
Parking and storage - The Telescopic Tube or Tritube can be parked for temporary storage dur-
ing cleaning or in the storage position when not in use (P13 & P14).
Nanopack Storage System (depending on model) -The unique Nanopack Storage System al-
lows the cleaner to be stored in an ultra compact confi guration with a signifi cantly smaller storage
volume than other cleaners.
To store the cleaner using the Nanopack system:
1. Detach the fl oor nozzle and hose handle from the Tritube then collapse the Tritube to its
minimum storage length (see 'Telescopic Tritube').
2. Position the cleaner in the upright position and slot the tool storage bracket on the Tritube into
the recess located on the base of the cleaner (P15).
3. Wrap the hose around the product before fi tting the hose handle and fl oor nozzle into the
locations provided on the tool storage bracket (P16).
0565_5319_d2.indd Sec1:7 0565_5319_d2.indd Sec1:7
7
EN
25/03/2008 12:27:11 25/03/2008 12:27:11