Troubleshooting - Dometic WAECO MagicSafe MS660 Instrucciones De Montaje Y De Uso

_MS660.book Seite 98 Montag, 2. August 2010 8:03 20

Troubleshooting

➤ Open the sensor.
NOTICE!
A
Ensure the polarity of the batteries is correct when inserting. The
positive pole is at the top.
➤ Change the battery (battery type CR 2032, 3 volts).
➤ Refit the lid on the sensor and re-insert the screw.
➤ Reattach the sensor.
11 Troubleshooting
The range of the hand-held transmitter is decreasing.
The batteries are flat.
You have lost the hand-held transmitter or it has been damaged.
➤ Deactivate the alarm system using the electronic key or the PIN code (see
chapter "Deactivating MagicSafe without the hand-held transmitter" on
page 89).
The indicators flash only once within 2 sec. instead of twice when you
switch the alarm system on.
The alarm system is warning you that a door or the bonnet or boot is open.
➤ Deactivate the alarm system.
➤ Rectify the fault.
➤ Reactivate the alarm system.
The indicators flash only once briefly (0.5 sec.) instead of once for
longer when you switch the alarm system off.
The alarm system has triggered an alarm.
➤ Sort the alarm memory.
This indicates the sensor which has triggered the alarm (see correspond-
ing table in chapter "Displaying the cause of the alarm" on page 94).
98
MagicSafe MS660