Dometic WAECO MagicSafe MS660 Instrucciones De Montaje Y De Uso página 76

_MS660.book Seite 76 Montag, 2. August 2010 8:03 20
Connecting the power to MagicSafe
One open and negative pulse control cable: fig. h, page 10
One +12 V and negative pulse control cable: fig. i, page 10
Connection to central locking system WAECO MagicLock ML44 and
ML22: fig. j, page 11
No. in fig. e
to fig. i
1
➤ Insulate any unconnected cables.
Grey/white (P4)
This cable provides an additional earth controlled input for optional
accessory modules (e. g. wired magnetic contact switch).
Blue (P5)
The external backup siren MS-670SI (accessory) can be connected to this
cable.
➤ Connect the blue cable to siren MS-670SI in accordance with fig. a,
page 6.
Grey cable belonging to MS-670SI
If you have installed the bonnet contact switch belonging to MS660 (see
chapter "Installing the bonnet contact switch" on page 68), you have to
connect it to the grey cable belonging to siren MS-670SI.
➤ Connect one end of the grey cable to the cable of the bonnet contact
switch.
➤ Connect the other end of the grey cable to the grey cable (P8) belonging
to MS660.
Green/red
This cable serves as a convenience output. The convenience output is
earthed and can be charged with up to 1 A.
NOTICE!
A
When connecting consumers with a power consumption of more
than 1 A (e. g. dipped headlights), an additional operating current
relay must be used.
76
Designation
Control unit for the vehicle's own central locking system
MagicSafe MS660