Installing The Controller - Dometic WAECO MagicSafe MS660 Instrucciones De Montaje Y De Uso

_MS660.book Seite 67 Montag, 2. August 2010 8:03 20
MagicSafe MS660
Insulating tape (14)
Heat shrinking sleeve
Cable bushing sleeves (optional)
To secure the cable you may require additional screws and cable binders.
6.2

Installing the controller

➤ Select a suitable installation location (fig. 6, page 4).
NOTE
I
When selecting the installation location, observe the following
instructions:
➤ Install the control unit
– in the vehicle interior
– with the main connection cable facing downwards
– under the dashboard
– not in areas where strong electrical fields could cause interference,
e. g. ignition cables or central control electronics,
– not directly next to ventilator nozzles.
➤ Where possible, use existing holes in the vehicle.
➤ Screw the control unit firmly to the vehicle with the screws supplied or use
double-sided adhesive tape.
6.3 Installing the ultrasonic module
➤ Select a suitable installation location close to the control unit.
➤ Screw the ultrasonic module firmly to the vehicle with the screws supplied
or use double-sided adhesive tape.
6.4 Installing the ultrasonic sensors
➤ Select a suitable installation location on the left and right A-pillars.
➤ Align the ultrasonic sensors with the middle of the rear window.
➤ Tightly fasten the ultrasonic sensors using the screws provided.
➤ Lay the cables down along the A pillar and over the dashboard to the
ultrasonic module.
Installing MagicSafe
67