BH FITNESS G-6442 Instrucciones De Montaje Y Utilización página 16

FOLDING YOUR UNIT.-
To fold your unit, stop the machine
completely and unplug it from the wall
socket. Lift the base of the machine,
pull pin (S), as shown in Fig.4 until it
clips into the frame. You can now
release the machine.
UNFOLDING YOUR UNIT.-
To unfold the machine carry out the
procedure in reverse, i.e. hold the
machine with one hand and use the
other hand to pull pin (S) in the
direction of the arrow, Fig.4 and lower
the machine gently onto the floor. and
lower the machine gently onto the
floor. When folding or unfolding the
treadmill make sure that there are no
children about or obstacles that might
hinder the folding motion.
ELEVATION SYSTEM.-
This unit has 2 levels of inclination.
Carry out the following steps to use the
different positions:
VERY IMPORTANT: First make sure
that the unit has stopped completely.
Fold the unit as shown in Fig.4.
If you only want the machine to be
slightly inclined, place the rear bar with
wheels (v) into position 1, see Fig.4A.
If you want the machine to be fully
inclined, place the rear bar with wheels
(v) into position 2, see Fig.4A.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (P),
Fig.5 to make it easier to move. Make
sure that the mains cable is unplugged
from the wall socket.
If you wish to move the treadmill, the
first thing to do is to fold it up, place
your hands on the handrails (G & H)
and tilt the treadmill, Fig.5, so that the
wheels (P) rest on the floor.
To prevent accidents DO NOT move
the treadmill across uneven floors.
MAINTENANCE.-
Use the bottle of lubricant (i) to
lubricate the inside of the belt in order
to keep your unit in top condition and
to ensure that friction between the belt
and the board is kept to a minimum,
Fig.6 (due to different running styles,
always apply more lubrication to the
area where you place your feet during
the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band every month, depending on how
often it is used.
Operating speed
1~6 km
6~12 km
12~16 km
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 5 mm Allen
key (f) and with the machine set to 4
km/h turn screws (R & L) one turn in a
clockwise direction.
ADJUSTING THE BELT.-
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways.
If the belt does shift to the left or right,
stop the machine.
16
Recommended
lubrication period
1 year
6 months
3 months