Operation - Orbitalum GF 4 AVM Traducción Del Manual De Instrucciones Original

GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
9.

OPeRATIOn

DAnGeR!
DAnGeR!
DAnGeR!
DAnGeR!
WARnInG!
WARnInG!
WARnInG!
WARnInG!
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
Machine start-up due to unintentional pressing of the On/OFF switch!
Fatal electric shock.
Diverse physical injuries and material damage.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
When the slide housing is rotating, excess lubricant can get into the motor unit!
Fatal electric shock.
X Remove excess lubricant from the machine after every step.
Unexpected start-up!
Serious injury or death.
X Before connecting the machine to the power supply, check the on/off switch is switched off.
Loose/baggy clothing, long hair or jewelry can get caught in rotating
machine parts!
Serious injury or death.
X Wear tight-fitting clothing when using the machine.
X Tie up long hair to prevent it from being caught.
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X Do not process the pipe while it is loose in the vice.
X never use a damaged or deformed saw blade or bevel cutter.
X In the event of tool breakage with a new tool, do not enter the old cut because the tool can
break again (for details of what to do in the event of tool breakage, see chap. 10.4.1, p. 100).
X Clamp the pipe to be cut into the vice.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X Pipe dimension must be set correctly. During cutting, the saw blade must saw through
the entire pipe wall.
X Avoid breaking tool through low (adequate) feed force, correct dimension (see chap. 8.6,
p. 82) and speed (see chap. 8.7, p. 85) settings.
X Hold on to the motor unit tightly by the handle, and guide it with low (adequate) feed
force during the machining process.
Risk of machine and pipe falling!
Irreversible crushing.
X Check the machine's position and secure it so it cannot fall.
X Place sufficient supports under the tube (see chap. 8.1.3, p. 78).
Trapped fingers between the vice/clamping shell and pipe!
Irreversible crushing.
X Do not insert fingers between the vice/clamping shell and pipe!
Body parts can fit between the cutting tools and the pipe!
Serious injury.
X Do not place body parts between the cutting tools and the pipe.
Operation
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
87