Environmental Protection - Worx WX292 Manual Original

LED Light Indicator
Before operation, the LED light
will be activated when the On/
Off switch is slightly depressed,
and will automatically turn off 20
seconds after the On/Off switch is
released.
The tool and battery are
equipped with a protection
system. When the LED Light
is quickly flashing 3 seconds
and turn off, the system will
automatically cut off power to
the tool to extend battery life.
The tool will automatically stop
during operation if the tool and/
or battery are placed under one
of the following conditions:
• Overloaded: The tool is
operated in a manner that causes
it to draw an abnormally high
current. In this situation, release
the Trigger Switch on the tool and
stop the application that caused
the tool to become overloaded.
Then pull the Trigger Switch
again to restart.
• Overheated: Under the
condition above, if the tool does
not start, the Tool and Battery are
overheated. In this situation, let
the Tool and Battery cool before
pulling the Trigger Switch again.
• Low battery voltage: The
remaining Battery capacity is too
low and the tool will not operate.
In this situation, remove and
recharge the Battery.
Warning:
To turn on the light, press
the On/Off switch and make sure
the Forward/Reverse Rotation
Control is on right/left position.
Lithium-ion Brushless Impact Driver
TROUBLE SHOOTING
1. I CAN NOT FIT THE BATTERY INTO
THE BATTERY CHARGER. WHY?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the red
LED Light should turn on when the battery is
charging.
2. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and
having not used a Battery Pack for a
prolonged time will reduce the Battery Pack
working time. This can be corrected after
several charge and discharge operations by
charging & working with your drill. Heavy
working conditions such as large screws
into hard wood will use up the Battery Pack
energy faster than lighter working conditions.
Do not re-charge your Battery Pack below
0 C and above 30
See Fig. E
o
performance.
MAINTENANCE
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free
of dust. Occasionally you may see sparks
through the ventilation slots. This is normal
and will not damage your power tool.
ENVIRONMENTAL
PROTECTION
Check with your local authorities or retailer for
recycling advice.
C as this will affect
o
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
11
EN