Haier HWF5300AW Manual Del Usuario página 27

English
Repairs to the washing machine must only be carried out by qualified personnel. Repairs
carried out by inexperienced persons may cause injury or serious malfunctioning.
Contact your local service center.
Problem
Water in the washer
does not drain or
drains slowly
Washer does not start
Washer won't spin
Long wash cycle time
Washer odor
The door cannot be
unlocked by touching the
Start/Pause pad to stop the
washer.
The water supply and
drainage does not stop
25
Possible Cause
Drain hose is bent or
clogged.
The Button/Coin trap is
clogged.
Check height of drain hose
it should be less than 96"..
Electrical power cord
may not be plugged in or
connection may be loose.
House fuse is blown, circuit
breaker tripped, or a power
outage has occurred.
Water supply tap is not
turned on.
Check that the door is firmly
shut.
The washing time may vary
with the amount of laundry,
water pressure, water
temperature, and other
using conditions.
Does not use HE detergent.
Stains under the door seal.
The water temperature or
the level is high.
Check that the height of the
drain hose is below 30".
Check if the end of the drain
hose is in the water.
Solution
Clean and straighten the
drain hose.
Clean the Button/Coin trap.
See "Drain System" Adjust
height of drain hose.
wall outlet.
Reset circuit breaker or
replace fuse. Do not
increase fuse capacity.
If problem is a circuit
overload, have it corrected
by a qualified electrician.
Turn on water supply tap.
Close the door and Touch
the Start/Pause pad. After
Touching the Start/Pause
pad, it may take a few
moments before the clothes
washer begins to spin.
If imbalance is detected or if
the suds removing program
operates, the wash time
shall be increased.
Use only HE detergent.
Wipe off the stains.
Leave door ajar after use.
Drain the water by using
Rinse&/Spin cycle. (The
door may be opened after
the Rinse&/Spin cycle is
complete.)
Adjust the height of the
drain hose.
Place the end of the drain
hose away from the water
surface.