Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation requirements and location
Please take precautions during installation of the appliance,
appropriate details are given following.
This appliance must be installed in xed installation on a
solid oor to minimize the duration during the spin cycle.
Concrete ooring is best, but a wood base should be
enough. This appliance should not be installed on rugs
or exposed to weather.
Plumbing
Water pressure - Must be 137 kPa minimum to 827 kPa
maximum.
Water temperature - Household water heater should be
set to deliver water at 120
º
to 150
washer when hot wash is selected.
should be supplied.
Drain - Water may be drained into standpipe or to the
than 30 inches (76 cm), or no more than 6 feet (1.8 m)
above the base of the washer. Standpipe must be
1-1/2 inches minimum inside the diameter and must
be open to the outdoors.
Step 1 Prepare the area and exhaust for installation of
appliance (see section 1).
Step 2 Check and ensure the existing external exhaust is
clean (see Section 1) and that it meets attached installation
Step 3 Remove the foam shipping pads (see section 1).
Step 4 Move the dryer to the desired location.
Step 5 Connect the power supply (see section 2).
Step 6 Connect the external exhaust (see section 4).
Step 7 Level the appliance (see section 5).
Step 8 Connect to plumbing facilities (see section 8).
For appliances with ventilation openings in the base, that a carpet must not obstruct the openings;
-
-
other fuels.
NOTE: This instruction is not required if the tumble dryer discharges the air into the room.
That the appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite
-
side to that of the tumble dryer, in such a way that a full opening of the tumble dryer door is restricted. If the installation
instructions state that the tumble dryer can be placed on top of a washing machine, they shall state which washing
machines are suitable. Instructions shall be given for the assembly of the tumble dryer and washing machine. The
Installation instructions
º
F (50
º
to 66
º
C) in the
14
Electrical requirements
Caution: Before plugging in washer, read and follow the
electrical requirements.
Caution: This appliance should be connected to a xed
istallation convered by a rigid tube. For personal safety,
do not use an extension cord or adapter plug with this
appliance. Do not, under any circumstances, cut or remove
the third (grounding prong) from the power cord. Follow
national electrical codes and ordinances.
This appliance must be supplied with the voltage and
on the front of the washer), and connected to a properly
grounded branch circuit, protected by a 15- or 20-amp
circuit breaker or time-delay fuse. If the electric supply
provided does not meet the above requirements, call a
licensed electrician.
Step 9 Check the operation of the power supply and
venting.
Step 10 Place the owners manual and the installation
instructions in a location where they will be noticed by
the owner.
For xed, and bedroom or closet installation,
see section 10.
For bathroom or bedroom installation, see section 11.
For mobile or manufactured home, see section 9.
For side or bottom exhaust, see section 6.
Tabla de contenido
