Package Contents; Assembly And Adjustments - DeWalt DWH051-XJ Manual De Instrucciones

– Health hazards caused by breathing dust
developed when working in concrete and/or
masonry.
Markings on Dust Extraction System
The following pictograms are shown on the tool:
Read instruction manual before use..
Wear eye protection.
DATE CODE POSITION
The date code, which also includes the year of
manufacture, is printed on the main information
label.
Example:
2011 XX XX
Year of Manufacture

Package Contents

The package contains:
1 Chipping dust extraction system
3 Dust shrouds
2 Tool holder adaptors
1 Kitbox
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Dust extraction system
b. Adaptor 1
c. Adaptor 2
d. Latch
e. Dust shroud (long)
f. Dust shroud (medium)
g. Dust shroud (short)
h. Connection point
NOTE: To select the correct tool holder adaptor
reference the information label on the inside of the
kit box lid.
INTENDED USE
Your chipping dust extraction system has been
designed for professional chipping and chiselling
applications in concrete and masonry. Using the
appropriate hammer drill, chisel and dust extractor
it can be used to remove the vast majority of static
and airborne dust which without the use of the dust
extraction system could otherwise contaminate the
working environment or pose an increased health
risk to the operator and those in close proximity.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
The chipping dust extraction system is a
professional tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
NOTICE: The chisel must not extend
more than 125 mm or less than 60 mm
from the end of the dust shroud for
optimum performance (figure 5).
NOTICE: Ensure the adaptor and all
surfaces are free from oil and grease.
The dust extractor will not fit securely
if parts are oily or greasy. Refer to
Cleaning paragraph.
Attach Dust Extraction System
(fi g. 1–5)
NOTE: Remove chisels or accessories from tool.
1. Select the correct dust shroud (e, f, g)
depending on the length of the chisel (j) or
accessory to be used.
2. Fit the selected dust shroud (e, f, g) onto the
dust extraction system (a). Pull the lugs (k) to
attach and release dust shroud.
3. Select the correct adaptor (b, c). Push the
adaptor as far as it will go onto the tool
holder (l).
NOTE: To select the correct tool holder
adaptor reference the information label on the
inside of the kit box lid.
EN G LI SH
21