SOLAC BA5510 Instrucciones De Uso página 12

USE OF THE SUPPORT WITH THE BOWL 12
• For doughs that need a long mixing time, use the support (12) and the bowl
(13). In this way, you will save having to hold the appliance in your hand
and you will achieve a uniform mix, as the bowl rotates automatically.
• Place the bowl with the rods (13) on the support base (12) (fig.6).
• To fit the main body (1) on the support (12): engage the slot at the back of
the main body on the locking tab (15), then press down until the anchoring
tab (14) engages in its seat (fig.7).
• To fit the rods, slide the tab (16) out and turn the top part (fig.8).
• IMPORTANT: The blender rod with the metal washer must be inserted in
the wide hole.
• Move the main body forwards again until engaging the tab (16), so that the
rods are in the bowl (fig.9).
• To start the appliance, follow the same steps as in section B.- Operation. In
this case, the appliance may be operated for a maximum of 10 minutes.
• The bowl will rotate automatically during the process so as to achieve a
uniform mix.
• To remove the bowl, turn the top so that the rods are out.
USING THE BLENDER ARM 10
• Before attaching the blender arm (10) to the body of the appliance, make
sure that it is switched off and unplugged.
A. FITTING THE BLENDER ARM 10
• Slide the coupling cover (3), insert the arm in the coupling (2) by lining up
the mark on the arm (▲) with the mark on the coupling side (▼) and turn
the arm 90º in a clockwise direction (fig.10).
• Make sure that the arm is attached properly.
• Plug in the appliance.
• Select "speed 3" when you want to use the blender arm.
• Never use the blender arm in the "TURBO" position.
B. OPERATION
• Insert the blender arm in the food to be mixed and slide the speed selec-
tor (7) to the desired position (fig.11). Never use the blender arm for more
than 2 minutes running.
• Do not insert the blender arm into boiling or very hot foods.
• If you want, you can use the jug (11) attached or any other container. If you
want to use the bowl (13), it is best to remove it from the support.
• To remove the blender arm, unplug it and turn it 90º in a clockwise direc-
tion (fig.12).
12 12
5510 BATIDORA 12 20/1/05, 09:59:29