Electrical Connection; Installation Into The Cabinet Cutout; Service; Data Plate - Bosch HWD57 Manual De Instalación Y De Usario

Electrical Connection

1. Connect warming drawer power cord.
Insert plug into three-prong, grounded outlet. See
"Power Requirements and Grounding" above for
electrical specifications.
2. Refer to the Steam Oven or Microwave installation
manual for the relevant instructions for connection to
the power supply junction box.

Installation into the Cabinet Cutout

1. Install the warming drawer and Steam Oven or
Microwave assembly into the cabinet cutout.
9 CAUTION
It is recommended to have 2 installers to install the
unit assembly. Failure to do so may result in
property damage or personal injury.
Slide the assembly into the cabinet cutout until it is
flush with front of the cabinet. Secure through screw
holes in cleats (drill pilot holes in cleats first if
necessary). See installation dimensions diagram.
Secure microwave/steam oven according to installation
instructions provided with those units.
2. Replace drawer.
• Be sure cabinet rails are pushed inside cabinet.
• Align the rails on the drawer rails with the rails
attached to the drawer housing.
• Firmly push the drawer straight into the drawer
housing until the drawer clicks into place. The
drawer should insert easily. If it binds, do not
attempt to force it. Remove the drawer, align the
slides on the housing to the front edge of the
housing and try again. Slide the drawer into both
housing slides at the same time, and keep the
drawer level while doing so.
• The drawer has a "push-to-open" operation.
Pressing the front of the drawer inward causes the
drawer to self open.
• Open and close drawer to test operation. Note: if
the drawer will not close, verify that the rail release
levers are properly positioned.
3. Turn power on at the service panel.
4. Test the installation.
Turn the warming drawer on. Signal light and timer
should turn on immediately. Check for warmth.
English 6

Service

If the warming drawer elements or signal light do not turn
on, check the power source to see if the circuit breaker is
tripped.
See Use and Care Manual for troubleshooting information.
Refer to the Statement of Limited Product Warranty in the
Use and Care Manual.
To reach a service representative, see the contact
information at the front of the manual. Please be prepared
with the information printed on your product data plate
when calling.

Data Plate

The data plate shows the model and serial number. Refer
to the data plate on the appliance when requesting service.
The data plate is visible on the left side of the drawer
casing. It may be necessary to remove the drawer to view
it.