Tabla de contenido
,_
WARNING:
Always stop engine, disconnect
spark plug wire and move it away from the
spark plug before performing any adjustments
or repairs on the snow thrower.
WARNING:
Never attempt to clean the
discharge chute or make any adjustments
while the engine is running.
Augers
The augers are secured to the spiral shaft with two
shear bolts and hex lock nuts. If snow thrower hits a
hard foreign object or ice jam, the bolts may shear.
Refer to Figure 15. If the augers will not turn, check to
see if the bolts have sheared.
Use replacement shear bolts and lock nuts provided
with the snow thrower. When replacing bolts, spray an
oil lubricant into shaft before inserting new bolts.
IMPORTANT:
Never replace auger shear bolts with
standard hex bolts. Any damage to the auger gearbox
or other components from hex bolt usage will not be
covered by the snow thrower's warranty.
Shave Plate and Skid Shoes
1.
The shave plate and skid shoes on the bottom of
the snow thrower are subject to wear. Check
periodically and replace when necessary.
2.
Remove the four carriage bolts and hex nuts which
attach two skid shoes to the snow thrower on two
sides. See Figure 16.
3.
4.
Shear Bolts
_
i
\
_Wa;her_
Carriage
\_
.._...
Bolt
Shave
Mex Nut
Plate
Figure 16
Reassemble new skid shoes with hardware
removed earlier. Make sure that skid shoes are
adjusted to be level.
To remove the shave plate, remove the carriage
bolts and hex nuts which attach the shave plate to
5.
the snow thrower housing. See Figure 16.
Reassemble the new shave plate with heads of
carriage bolts to the inside of the housing. Tighten
securely.
Belt Replacement
NOTE: If changing one belt, check condition of the
other belt. We recommend changing both belts at the
same time.
1.
Disconnect the chute directional control assembly
at the discharge chute end by removing the hairpin
clip and the flat washer.
2.
Remove the plastic belt cover at the front of the
engine by removing the two self-tapping screws.
See Figure 17.
Self-Tapping Screw
3.
4.
%_Self-TappingScrew
Figure 17
Drain the gasoline from the snow thrower, or place
a piece of plastic film under the gas cap.
Tip the snow thrower up and forward so that it rests
on its auger housing. See Figure 18.
Housing
Figure 18
5.
Remove the four self-tapping screws from the
frame cover underneath the snow thrower.
15
Tabla de contenido
