Tabla de contenido
Lubrication
Engine
Refer to the separate engine manual packed with your
unit for all engine lubrication instructions.
Gear Shaft
Lubricate the gear shaft with 6-n-1 grease at least once
a season or after every 25 hours of operation (available
at automotive stores). Refer to Figure 26.
IMPORTANT:
Keep all grease and oil off the rubber
friction wheel and aluminum drive plate.
Chute Directional
Control
The worm gear on the chute directional control should
be greased with multipurpose automotive grease.
Gear Case
The gear case is lubricated with grease at the factory
and does not require checking. If it is disassembled for
any reason, lubricate with 2 ounces of Shell Alvania
grease EPR00. Before reassembling, remove old
sealant and apply new sealant.
Drive Control / Auger Control Lock
The cams on the ends of the control rods which
interlock the drive control and auger control must be
lubricated at least once a season or every 25 hours of
operation. The cams can be accessed beneath the
handle panel. Use a multi-purpose automotive grease.
See Figure 14.
Handle Panel
Figure 14
Auger Shaft
At least once a season, remove the shear bolts from the
auger shaft and spray lubricant inside the shaft. See
Figure 15.
Grease fittings can be found at either end of the auger
shaft. Lubricate with a grease gun once a season. See
Figure 15.
Auger Bearings
Every season lubricate the auger bearings and the
bearings on the side of the frame with light oil. See
Figure 15.
Grease Fittings
St_ear
Plastic
Bolt
Bearing
Shear
Plastic
Bearings
Bolt
Bearing
Figure 15
Drive and Shifting Mechanism
Lubricate at least once a season or after every 25 hours
of operation. Remove the rear cover, lubricate any
chains, sprockets, gears, bearings, shafts, and shifting
mechanism at least once a season. Use engine oil or a
spray lubricant. Avoid getting oil on the friction
wheel rubber and aluminum
drive plate. There is a
grease fitting on top of the axle shaft. Grease these
fittings every 25 hours or once a season.
Check V-Belts
Follow instructions below to check the condition of the
drive belts every 25 hours of operation.
1.
Remove plastic belt cover from front of the engine
by removing two self-tapping screws.
2.
Visually inspect for frayed, cracked, or excessively
worn out belts. Replace, if necessary, following
instructions on page 15. Re-assemble belt cover.
Check Friction Wheel
Follow instructions below to check the condition of the
friction wheel rubber every 25 hours of operation.
1.
Remove the four self-tapping screws from the
frame cover underneath the snow thrower.
2.
Visually inspect the friction wheel rubber for
excessive wear, cracks, or loose fit on the friction
wheel drive hub.
3.
Also engage the drive control and check if the
friction wheel is making contact with friction plate. If
it does not make contact, adjust the drive control
cable and recheck the friction wheel.
4.
Replace friction wheel rubber if necessary. Refer to
instructions on page 16. Re-assemble frame cover.
14
Tabla de contenido
