Grundfos DIT-IR Installation And Operating Instructions página 10

Data acquisition, Excel template:
Option, note pad
After selecting the note pad mode, a window opens. Enter the file
location and name of the data to be transmitted.
After confirmation of the file location, the operating interface
opens:
In this window, the transmitted data can be viewed and stored.
Settings of the DIT-IR can be changed. See section
5.3.3 Configuration of the DIT-IR settings.
If the print command on the photometer has been pressed,
the transmitted data can be seen in the operating interface.
Data acquisition operating interface:
10
The data will be stored automatically in the assigned location and
named as a .txt file.
5.3.3 Configuration of the DIT-IR settings
With the data acquisition software, various settings on the DIT-IR
can be changed. The settings can be found under Settings > IRIM
Module.
The window below opens. Set the baud rate, turn-off time
("Power Down") and the transmission protocol.
Default configuration: 9600 baud and protocol "None".
For any changes to the default settings, refer to the PC or device
manuals. The turn-off time can be set between 1 and
120 minutes. The turn-off time is inactive if the DIT-IR is powered
by the USB-PC connection.