Pressure Testing; Replace Blue Pressure Test O-Ring If Necessary; Remove Pump Lid - Zodiac Jandy Pro Serie Manual De Instalación Y Operación

Page 12
ENGLISH
Lid with
Locking
Ring
Seal
Blue Pressure Test O-ring
Figure 6. Blue Pressure Test O-ring in Lid Assembly
Lid with
Locking
Ring
and
Seal
Blue
Pressure
Test
O-ring
(Note: Discard
after pressure
test is complete.)
Pump
Debris
Trap
Basket
(Inside
Pump)
Figure 7. Exploded View of Pump
Jandy Pro Series ePump™ Series Pump | Installation and Operation Manual
®
Switch 3 Switch 4 Pump Address
OFF
ON
OFF
ON
3.4
All Jandy Pro Series model ePumps come with an
additional disposable o-ring for pressure testing. This is
the blue pressure test o-ring. See Figures 6 and 7.
Do not open the pump lid before pressure testing,
because the blue pressure test o-ring may fall out.
If this happens, you will need to place it back on the
lid.
If you have not opened the pump lid, skip to Section
3.5, Conducting Pressure Test.
3.4.1 Replace Blue Pressure Test O-ring if
If you open the pump lid before conducting the
pressure test, the blue o-ring will probably fall out. If
this happens, you will need to install it on the lid again
before conducting pressure testing.
There is a risk of damage to the blue o-ring during
re-installation. If you damage it when trying to re-install
it, you will need to order a new blue pressure test o-ring
before you begin conducting the pressure test.
These instructions describe the proper procedures
for replacing, using, and disposing of the blue o-ring.
These instructions must be followed exactly. Read
through the instructions completely before starting the
procedure.
3.4.1.1
1. Make sure that the pump is turned off.
2. Make sure that the switch to the circuit breaker
that powers the pump motor is turned off.
Turn off the pump and the main breaker in the pump
electrical circuit before starting the procedure. Failure
to comply may cause a shock hazard, resulting in
severe personal injury or death.
OFF PUMP 1
OFF PUMP 2
ON PUMP 3
ON PUMP 4

Pressure Testing

CAUTION
Necessary

Remove Pump Lid

WARNING
ELECTRICAL SHOCK HAZARD