Sears Craftsman 247.88790 Manual Del Propietário página 21

2. Adjust equally on both sides by working on both
cables. See Figure 30.
Chute Control Cable
Figure 30
Drive Control
Refer to the Final Adjustment section of the Assembly
instructions to adjust the drive control. To check the
adjustment, proceed as follows:
1. With the snow thrower tipped forward (be certain to
drain gasoline or place plastic film under the gas
cap if the snow thrower has already been
operated), remove the frame cover underneath the
snow thrower by removing the self-tapping screws.
2. With the drive control released, there must be 1/8"
clearance between the friction wheel and the drive
plate in all positions of the shift lever.
3. With the drive control engaged, the friction wheel
must contact the drive plate.
4. If adjustment is necessary, loosen the jam nut on
the drive cable and thread the cable in or out as
necessary. Tighten the jam nut to secure the cable
when correct adjustment is reached.
5. Reassemble the frame cover and turn the unit back
to its operating position.
NOTE: If you placed plastic under the gas cap, be
certain to remove it now.
Auger Control
To adjust the auger control, refer to page 7.
Skid Shoes
To adjust the skid shoes, refer to page 8.
21