Canceling The Demo Mode; Preparing The Card Remote Commander; Setting The Clock; Detaching The Front Panel - Sony DSX-S310BTX Manual De Instrucciones

Canceling the Demo mode

You can cancel the demonstration display which
appears during turning off.
1
Press and hold the multi-way encoder.
The setup display appears.
2
Rotate the multi-way encoder to select
"Demo," then press it.
3
Rotate the multi-way encoder to select
"off."
4
Press and hold the multi-way encoder.
The setup is complete and the display returns
to normal reception/play mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 45.

Setting the clock

The clock uses a 12-hour digital indication.
1
Press and hold the multi-way encoder.
2
Rotate the multi-way encoder to select
"Clock Adjust," then press it.
The clock adjustment display appears.
3
Rotate the multi-way encoder to set
the hour and minute.
To move the digital indication, push the
multi-way encoder left/right.
4
After setting the minute, press the
multi-way encoder.
The clock starts.
Tip
You can set the clock automatically with the RDS
feature (page 19).
8

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press and hold (SOURCE/OFF).
The unit is turned off.
2
Press (OPEN).
The front panel is flipped down.
3
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.
• If "Device Inside" (page 44) appears in the display or
the Device Inside Alert LED flashes, detach the front
panel and remove the USB device or iPod.