Mixing Fuel; Filling The Fuel Tank - Shindaiwa M230 Manual Del Operador

Mixing Fuel

CAUTION!
Some types of gasoline contain alco-
hol as an oxygenate. Oxygenated
gasoline may cause increased oper-
ating temperatures. Under certain
conditions, alcohol-based gasoline
may also reduce the lubricating
qualities of some 2-cycle mixing
oils. Never use any type of gasoline
containing more than 10% alcohol
by volume! Generic oils and some
outboard oils may not be intended
for use in high-performance engines,
and should never be used in your
Shindaiwa engine.

Filling the Fuel Tank

WARNING!
Minimize the risk of fire!
■
STOP engine before refueling.
■
ALWAYS allow the engine to cool
before refueling!
■
Wipe all spilled fuel and move the
engine at least 10 feet (3 meters)
from the fueling point and source
before restarting!
■
NEVER start or operate this unit if
there is a fuel leak.
6
■
Use only fresh, clean unleaded gasoline
with a pump octane of 87 or higher.
■
Mix all fuel with a 2-cycle air-cooled
mixing oil that meets or exceeds ISO-
L-EGD and/or JASO FC classified oils
at 50:1 gasoline/oil ratio.
CAUTION!
This engine is designed to operate
on a 50:1 mixture consisting of
unleaded gasoline and ISO-L-EGD
or JASO FC class 2-cycle mixing oil
only. Use of non-approved mixing
oils can lead to excessive carbon
deposits.
■
NEVER start or operate this unit if
the carburetor, fuel lines, fuel tank
and/or fuel tank cap are damaged.
■
NEVER smoke or light any fires near
the engine or fuel source!
■
NEVER place any flammable mate-
rial near the engine muffler!
■
NEVER operate the engine without
the muffler and spark arrester in
good working condition.
Examples of 50:1 mixing quantities
Gasoline 2-cycle mixing oil
liters
2.5 - 1
5 - 1
10 - 1
20 - 1
IMPORTANT!
Mix only enough fuel for your immediate
needs! If fuel must be stored longer than
30 days and oil with fuel stabilizer
is not used, it should first be treated with a
fuel stabilizer such as StaBil™.
Oil is a registered JASO FC
classified oil and also meets or exceeds
ISO-L-EGD performance requirements.
Shindaiwa One is recommended for use
in all Shindaiwa low emissions engines.
Shindaiwa One also includes a fuel
stabilizer.
1. Place the unit on a flat, level surface.
2. Clear any dirt or other debris from
around the fuel filler cap.
3. Remove the fuel cap, and fill the tank
with clean, fresh fuel.
4. Reinstall the fuel filler cap and tighten
firmly.
milliliters
50 ml
100 ml
200 ml
400 ml