Clatronic HDR 2941 Instrucciones De Servicio página 65

Replacing Accessories
1. Turn the device off by the main switch (1).
2. Allow the pressure to escape by operating the lever on the manual spray gun (8).
3. Secure the manual spray gun (8) with the lock (10).
4. Change to the desired accessory and then continue operation of the machine.
Finishing Operation
1. Switch the device off by the main switch (1).
2. Remove the mains plug (9) from the socket.
3. Close the water supply.
4. Allow any residual pressure to escape by operating the lever on the manual
spray gun (8).
5. Secure the manual spray gun (8) with the lock (10).
6. Disconnect the device from the water supply by unscrewing the hose on the
water connection (3) of the device.
The device must never be immersed in water to clean it, but should be cleaned
with a soft dry cloth. In the case of stubborn dirt slightly dampen the cloth with
water and then wipe dry.
Separate the accessories from one another. Allow the accessories and the high-
pressure hose to run empty.
Please note: There is still water in the pump of the high-pressure cleaner. Frost
may damage the pump or internal piping. Therefore the device should always be
stored in rooms away from frost.
Device is not working
• Check the mains connection.
• Check the position of the main switch (1).
The motor suddenly stops during operation
• Possible cause: The overheating protection of the pump has been activated.
Switch the machine off and allow it to cool down for approx. 20 min. Then you
can begin work again.
6....-05-HDR 2941 65
Cleaning
Storage
Troubleshooting
GB
65
07.01.2005, 14:32:18 Uhr