Oven Care And Cleaning; Self-Cleaning The Oven; Preparing The Oven For Self-Clean - Fulgor Milano FCO 300 P TM 2F Instrucciones Para La Instalación Y Uso

Abrasive detergents and steam cleaning equipment should
not be used for cleaning.
WARNING
Do not use harsh abrasive cleaners or sharp metal scrapers
to clean the oven door glass since they can scratch the
surface, which may result in shattering of the glass.
WARNING
Ensure that the door is in the closed position before the self-
cleaning cycle starts, otherwise automatic door locking
will not be completed. See paragraphs that follows.

Self-Cleaning the Oven

This oven features a pyrolytic self-cleaning function that
eliminates the difficult and time consuming manual scrubbing
of the oven interior. During self-cleaning, the oven uses a
very high temperature (approx. 860°F/460°C) to burn
away food soil and grease.
• It is common to see smoke and/or an occasional flame-up
during the Self-Clean cycle, depending on the content and
amount of soil remaining in the oven. If a flame persists,
turn off the oven and allow it to cool before opening the
door to wipe up the excessive food soil.
• The door latch is automatically activated after selecting
the Self-Clean cycle. The "PADLOCK" icon will appear in
the display. This ensures that the door cannot be opened
while the oven interior is at clean temperatures.
Hand clean frame
area ouside gasket
DO NOT
hand clean gasket
Hand clean door
area outside gasket

19 - Oven Care and Cleaning

• The oven light does not operate during this mode.
• During Self-Clean, the kitchen should be well ventilated to
help eliminate odors associated with Self-Clean. Odors
will lessen with use.
• Three hours is the preset length of cleaning.
• The mode automatically stops at the end of the clean
hours.
• When the oven heat drops to a safe temperature, the
automatic door lock will release and the door can be
opened.

Preparing the Oven for Self-Clean

1. Remove all utensils and bake ware.
2. Remove non-porcelain oven racks. If chromed racks
are left in the oven during the self-clean cycle, they will
permanently lose the shiny finish and change to a dull
dark finish.
3. Wipe up any soft soil spills and grease with paper towels.
Excess grease will cause flames and smoke inside the
oven during self-cleaning.
4. Review illustration below. Some areas of the oven must
be cleaned by hand before the cycle begins. They do not
get hot enough during the cleaning cycle for soil to burn
away. Use a soapy sponge or plastic scrubber. Hand-
clean the oven door edge, oven front frame and up to
1-½ " (2-3 cm) inside the frame with detergent and hot
water. Do not rub the gasket on oven. Clean by hand the
oven door window. Rinse all areas thoroughly then dry.
5. Be sure oven interior lights are turned off and the light
bulbs and lens covers are in place.
Hand clean door window
Hand clean 1" (2cm)
from rack guides
to frame of oven cavity
EN
31