Garland BEST 310 DPG Manual De Instrucciones página 36

English
the chain oil, all contain carbon monoxide and other
dangerous chemical substances.
In case of gas concentration due to
insufficient ventilation, eliminate from the
work area everything that impedes the
correct flow of air and do not work in this area again
until it is well ventilated and the gas concentration
does not happen again.
Never leave this machine unattended.
Never touch elements that can be hot during
the start up or operating the machine, for
example, the escape, sparks or high voltage
cables.
Always regulate the machine on a flat and stable
surface.
Do not use accessories except those recommended
by our company as otherwise the use of other non
original accessories could cause severe damages to
the end user, to passers-by and to the machine.
7.1. CUT WITH THE HEADER OF WIRE
WARNING: Wear eye and audible protection
at all times. Do not look directly to the
cutting line because can cause serious
damage to the head and the eyes.
Always wear protective mask while using this unit.
Use the head line in difficult areas. If the header hits
a rock or other object stop the machine and check its
status. Do not use damaged or poorly balanced heads.
Remember that the end of the nylon threat is the one
that makes the cut. Get a better result if you do not
introduce the entire head in the cutting area. Enter
the head slowly and let the nylon tips cut the grass at
their own pace.
Make cuts from the left to the
right to prevent that the grass
fall into the cutting area. Be
careful to not hit the head
with rocks or the ground. The
beatings against objects or the
ground will reduce the life of
the head, may spoil creating a
dangerous environment for you and the people close
to you.
The nylon threads are shortened with the use, when
they are too short accelerate the engine and press the
head against the ground. Then leave wire from the
head. If you leave too much wire the blade will cut in
excess.
WARNING DANGER: Do not operate the brush
cutter in areas with metallic materials. Always use the
proper protective equipment. Don't use this machine
in areas where you can't see properly.
7.2. CUT WITH THE DISC
1. Check the disc holder and make sure it is tight
and there are no signs of damage or abrasion.
2. Make sure the disc and disc holder are firmly
installed in accordance with the instructions and
that the disc spins freely without producing
abnormal sounds.
36/132
Hold the brush cutter in the way
that the head do not touch the
ground and with an inclination of
20º in the sense you are cutting.