Milnor 30022X8J Guía De Mantenimiento página 37

Maintenance Components—Large Extractors
3.1.6.
Figure 14: Oil Maintenance Areas for Bearing Assembly
1. Oil drain port. When you remove the used oil, remove spilled oil.
2. Oil fill tube and stopper. Do not let new oil get on drive components. After you change the oil,
secure the fill tube and vent tube behind the motor mount bracket as shown.
3. Housing vent tube
4. Seal cavity drain tube. Remove comtamination that flows from the tube.
5. Grease relief port. Remove grease that flows from this port.
.
Figure 15: Grease Ports for Oil-filled Bearing Assembly with Seal Grease Maintenance. See also
Figure 14.
Grease Lubrication Plate 01-10025W
.
Views of Maintenance Areas
Legend
1. Seal grease port
2. On machines with grease plate 01-10025W,
the seal is the only bearing assembly
component that uses grease. The bearing
housing is oil-filled. See
requirements.
33
Chapter 3. Routine Maintenance
[Document BIWUUM03]
Legend
Table 4 for oil
PELLERIN MILNOR CORPORATION