Basic Programming; Advanced Programming - Aprimatic R1-24 Instrucciones Para La Instalación, Uso Y Mantenimiento

4. PROGRAMMING
Proceed as follows for basic and advanced programming.
IMPORTANT! Programming is only completed successfully when you exit the procedure. If the power supply to
the unit is disconnected before this happens then all the modifi cations made are lost.
The parameters cannot be programmed when the unit is only powered by the batteries.
!
Warning
All input signals will be ignored during programming.
4.1 BASIC PROGRAMMING (Fig.7)
Fig. 7
Press and hold R e l e a s e
the RED button button
PROC
until " " is letters to identify
shown on the the programmable
display. parameters are
displayed.
PROC
RED RED
YELLOW
Press the YELLOW button to exit
and return to normal functioning:
the displays are switched OFF.
4.2 ADVANCED PROGRAMMING (Fig.8)
Perform stages 1 and 2 in the Basic Programming procedure (fi g.7) - access and perform advanced programming by
following stages 3 to 9 in fi g.8.
Fig. 8
Press the BLUE Press the RED
button to scroll button to access
t h r o u g h t h e a d v a n c e d
parameters until p r o g r a m m i n g
PRoF
" " is shown a n d s h o w t h e
on the display. parameters.
ProF
BLUE
ESC
YELLOW
Press the YELLOW button
to exit and return to normal
functioning: the displays are
switched OFF.
t h e Press the BLUE
the fi rst button to scroll
t h r o u g h t h e
programmable
parameters.
LO.0
BLUE
ESC
P r e s s t h e
BLUE button to
scroll through
the advanced
parameters.
A4
A3
A1 A2
RED BLUE
YELLOW
Press the YELLOW button
to return to stage
Basic and advanced programming
Press the RED
button when a
p a r a m e t e r i s
shown to display
t h e c u r r e n t
setting (marked
by the dot).
O.
RED
If you decide not to make any modifi cations
press the yellow button
displayed again (stage
P r e s s t h e R E D
button when the
parameter to be
modifi ed is shown
and the value set is
shown (highlighted
by the dot).
00.
RED BLUE
ESC
Program this parameter starting from stage
.
advanced programming by pressing the YELLOW button
repeatedly until the displays are switched OFF.
- 27 -
P r e s s t h e Press and hold the RED
BLUE button to button for 3 seconds to
scroll through select the value required
t h e v a l u e s 3 fl ashes indicate the new
available for the setting is stored. Release
parameter. the RED button and press
the YELLOW button to
show the next parameter.
2
BLUE RED
ESC
YELLOW
the parameters are
).
Press the BLUE Press the RED button
b u t t o n a n d when the value required
scroll through i s s h o w n t o m a k e
t h e v a l u e s modifi cations 3 fl ashes
available for the confi rm that the value has
been modifi ed. Release
parameter.
the RED button.
00
01
RED
Press the YELLOW
button
ESC
p r o g r a m m a b l e
parameter is shown.
YELLOW
2.
the next
or exit